By MarEx 2015-10-05 22:52:05
Two companies have been sentenced after a worker was killed and another seriously injured during construction of an offshore wind farm.
The incident happened when a team of engineers were loading wind turbine blades onto a sea barge for delivery to Greater Gabbard, off the Suffolk coast in the U.K., on May 21, 2010.
During the loading of wind turbine components at Pakeston Quay, Harwich, a 2.11 ton part of the blade transport arrangement fell off, crushing and fatally injuring one worker and seriously injuring another.
Chelmsford Crown Court heard both workers were employed by Siemens Windpower A/S but were working for Fluor Ltd, the principal contractor.
The injured man, Frank Kroeger, was airlifted to Addenbrookes hospital in Cambridge where he was resuscitated twice. He suffered a ruptured spleen, lacerations to his liver, a collapsed lung collapsing, multiple rib fractures on his left side, and significant crush injuries to his right arm and hand, with nerve damage to his thumb and fingers.
His injuries were life-changing and required almost three weeks in hospital in the U.K., followed by a long period of rehabilitation and treatment near his home in Germany.
The family of the fatally-injured man has asked that his name not be released.
The investigation carried out by HSE found serious safety failings in the two firms’ management systems for the loading operation, which allowed vital parts of equipment to go unchecked before being lifted.
Following a four-week trial in July, prosecuted by the U.K. Health and Safety Executive (HSE), Fluor was found guilty of breaching Section 3 (1) of the Health and Safety at Work etc. Act 1974 and was ordered to pay £275,000 ($417,000) in fines and £271,048 ($411,000) costs.
Siemens Windpower was charged with the same offence and also a Section 2 (1) breach of the same act, but pleaded guilty at an earlier stage. They were ordered to pay £375,000 ($569,000) in fines with costs of £105,355 ($160,000).
Speaking after the hearing, HSE Inspector Julie Rayner said: “This incident could easily have been avoided had suitable systems and procedures been in place to ensure that all loads were properly connected whilst being lifted.
“Had the right questions been asked when the lift was being planned and had the bolt and two brackets holding the blade and frame together been checked before they were lifted, the death and serious injury of two workers could have been prevented.
“This case clearly highlights the need to ensure that relevant information is considered when lift plans are produced to ensure that all of the relevant risks are considered.”